Instructions:
1. Cut Razzleberry cardstock to desired size for top layer (example is 9” square) and round corners with punch.
2. Cut Light Birchtone and Purple cardstock slightly larger, round corners, ink edges of Light Birchtone.
3. Cut grape paper so it is ½” larger on all sides.
4. Cut Medium Birchtone slightly larger than grape paper.
5. Adhere all of the layers together except the top layer of Razzleberry.
6. Using the Light Birchtone cardstock cut three 2 ¾” circles and two ¾” wide strips the width of the top layer of the Razzleberry cardstock. Ink all edges with Olive Green ink from Queue.
7. Print desired quote on computer using Inkjet Transparency. Lay the transparency strips over the ¾” inked strips from step above and apply adhesive only where the photo will cover it.
8. Adhere each of these strips to 1” wide strips of Medium Birchtone cardstock
9. Punch holes with micro punch and insert brads on each end.
10. To make wire wine glasses, use 22 gauge Burgundy wire. Set up the Jewelry Jig following the pattern to set up pegs. Follow the direction on the pattern, leaving short tails. Remove from pegs, flatten with Nylon Jaw Pliers and trim off ends. Make 3 glasses.
11. To attach each of the glasses to circles, make tiny holes with needle tool or pin (place on foam cushion to do this) around various points of each glass. Make ½” horseshoe shapes with 26 gauge matching wire. Insert these horseshoe shapes through the tiny holes around wire shapes and secure by flattening on the back of the cardstock. Be sure to secure stem of each glass in the twisted design.
12. Cut photos to desired size, round corners and mat with Light Birchtone cardstock (be sure to round corners and ink edges).
13. Assemble rest of design elements on page and adhere with SuperTape. If a 3-D effect is desired, use foam squares for dimension.
14. Adhere top layer with SuperTape to the four layers already adhered together.